Device Connection Settings
The General settings are common to all Allen-Bradley devices, and the Connectivity settings are device dependent.
The user-defined name for this Device. The name chosen will show up in OPC Item Paths and under OPC-UA Server > Devices of the Configure page of the Gateway. The Device Name must be alphanumeric.
|Description||The user-defined description for the device. This is only used as a note to differentiate between devices.|
|Enable Device||Only devices that are enabled appear in Connections > Devices of the Status page of the Gateway and thus have their tags available for use.|
The Hostname value is the IP Address of the MicroLogix 1100 processor, MicroLogix 1400 processor or 1761-NET-ENI Ethernet interface. EthernetIP protocol on TCP port 44818 (0xAF12) is used to communicate to the listed devices.
The local address to connect from when establishing a TCP connection. If left blank, then the driver will simply pick an available address.
|Communication Timeout||After sending a request to the MicroLogix processor, the Communication Timeout setting is the amount of time in msec to wait for a response before treating it as a failure.|
|Browse Cache Timeout||When the data table layout is read from the MicroLogix processor, the Browse Cache Timeout value is the amount of time in msec to cache the results.|
Supported MicroLogix Connection Methods
- MicroLogix 1100 and 1400 direct
- MicroLogix 1100 and 1400 connected through 1761-NET-ENI
- MicroLogix 1100/1400 connected through Spectrum Controls WebPort 500
MicroLogix 1200 and 1500 are not fully supported. Browsing is not available on these devices, so the 'Disable Processor Browse' advanced property will need to be set to True on the device connection. Additionally, the MicroLogix driver can not access Input Parameters.
MicroLogix 1200 and 1500 are not fully supported. Browsing is not available on these devices, so the 'Disable Processor Browse' advanced property will need to be set to True on the device connection.
Additionally, the MicroLogix driver can not access Input Parameters.